Introducing the newest player in the home brewer mill market. This is a massive upgrade to our already successfull MM-2 mill, meant to compete and win against the best milling products available. It consists of a 6061 aluminum block frame with two 6" long, and 2" diameter steel rollers riding on SAE 841 oil impregnated bronze bushings. We use a superior grade of steel (1144 alloy) that is much harder than what is found on most comparable products and should last almost twice as long. The drive shaft, and all the axles are integral to the roller rather than screwed into the ends. This makes it fine to drive the mill clockwise, or counter-clockwise. All the axles are 3/8", with minimal freeplay in the bushings, and the larger 1/2" shaft comes standard. The larger diameter rollers allows a finer crush with more minimal husk damage, and milling at smaller gap settings without worry of skipping. This mill also comes with a much larger gap adjustment range of .160", more than double our standard range that should allow you to mill other grains like corn, as well as the conventional grist bills with barley.

One of the knurled steel rollers is driven by a standard 1/2" electric drill (not included) to feed the grain through the adjustable gap and crush the grist. Make sure you have a very robust 1/2" drive corded drill to drive this mill, we can't be responsible for drill death! : ) Don't even ask about a hand crank for this mill! Both ends of the non-driven roller ride in bushings that are offset mounted in an adjustable knob. The knob is held in a fixed position by a thumbscrew that you can loosen to adjust the mill. This system provides an adjustment range of .160". Our knobs are made from 303 stainless steel for excellent durability, and are larger in diameter than the competition, as well as knurled for a positive grip. We've also added a goove in our newest design knobs with a matching rounded head on the thumbscrew that allows for a much better grip on the knob to avoid gap changes while milling, and also providing knob retension. You need to fabricate a base and hopper to feed the grist through the mill. The mill can be mounted above or below the base and attached using the included mounting bolts.

International customers, please note that you MUST select International Express Air as your shipping preference when you check out using PayPal to be charged the correct shipping amount for an order with the MM2-2.0 mill, and a base and/or hopper. International orders with a base and/or hopper will incur additional shipping charges.

6" Long Adjustable Gap:

• fully adjustable mill
• dual eccentric adjusters: 0 to .160" gap - built from STAINLESS STEEL for no galling
• 6" long, 2" diameter 1144 alloy steel rollers
• drill-drive - CW, OR CCW
• alloy frame
• SAE 841 oil impregnated bronze bushings
• 1/2" integral drive shaft w/3 flats for drill driving, 2" long outside frame
• 3/8" integral axles